Arista EDU Ultra 200 Success

After developing a roll on Sunday with pretty good results I was emboldened to develop another roll.  While I was pretty happy with the results, I knew that I could do better.  You see, my goal is to go 95%+ all BW film by the end of the year and use digital only for those times when ultra high ISO is required.  So with this goal in mind I knew I had to do better.  Not that the shots were bad, I had quite a few on that roll that I am quite proud of.  So yesterday I decided to kill an hour or so and develop a roll of Arista EDU Ultra 200 to see how it would hold up to stand development.

I decided that I would put to test that all film regardless of ISO (ASA for us old folks), can be developed the same.  So into the tank went the film and developed for 1 hour in Adox Adonal at 1:100.  When the film came out I was very impressed with the results to the point of wanting to shoot some more of this film.  In fact I have reloaded my F100 with one of my two remaining rolls.

Here are two shots from that roll.  I’m sure you will agree that the results are most acceptable.  So what’s next?  I’m going to test the notion that stand development breaks the “One ISO for an entire roll of film” barrier.  This should prove fun.

 

Arista EDU Ultra 200 stand developed.

Arista EDU Ultra 200 stand developed.

Arista EDU Ultra 200 stand developed.

Arista EDU Ultra 200 stand developed.

Arista EDU Ultra 200 stand developed.

Arista EDU Ultra 200 stand developed.

A Start In Stand Developing

From the first time I heard about a technique where you could let your film sit in developer for an hour (or longer in some cases) that yielded usable negatives I knew I wanted to try it.  It couldn’t be simpler, really.   My method for one roll is:

  1. Mix 500ml water at 20C with 5ml of Adonal (this gives me my 1:100 ratio) and set it aside.
  2.  Start my timer for 1 hour and pour 400ml (my tank requires 375ml for a single roll) of water (at 20c) into the tank and let it soak for a couple of minutes then drain.
  3. Pour the 500ml of Adonal mix into the tank then give it three inversions.  I tap it on the counter twice to dislodge any air bubbles that may have developed on the film.  Then I set it on the kitchen counter.
  4. At the half-hour mark I give three inversions, tap on the counter twice, and return the tank to the counter.
  5. At the end of the hour I dump the tank, rinse for 6-7 minutes.
  6. Fix for four minutes normally.
  7. Rinse for a couple of minutes in photo flo.

Here are two images that resulted from the above technique.

Nikon F100 shot on Arista Premium 400

Nikon F100 shot on Arista Premium 400

Nikon F100 shot on Arista Premium 400

Nikon F100 shot on Arista Premium 400

 

I am quite pleased with the results from this roll and am sure that each successive roll will get even better as I refine my method. Thanks for taking the time to read my blog and as always I’m open to any an all comments.